Kwikset 99140-023 SmartCode 914 Traditional Smart Lock - Keypad Electronic Deadbolt with SmartKey Security & Z-Wave Plus Technology in Satin Nickel Finish | Secure Your Home, Office or Rental Property with Keyless Entry & Remote Access

The SmartCode touchpad smart lock with Home Connect technology enables the lock to wirelessly communicate with other devices in home. The lock allows the user (through a web enabled device) to remotely check the door lock status, lock or unlock the door and receive notifications. SmartCode is a one-touch locking motorized deadbolt. With your personalized code, you can enter your home with the convenience of keyless entry and the back-lit keypad provides increased visibility. This SmartCode deadbolt is easy to install, program and use, and operates on 4 AA batteries. It also features SmartKey Security as the back-up keyway. Kwikset smartcode dead bolts are available as smart locks and as electronic deadbolts to provide keyless entry and access for your daily life similar to our Kwikset Kevo door lock. Our Kwikset locks come with patented Kwikset only security features including- Kwikset smartkey security and SecureScreen. Our front door locks are the smart choice whether you are searching for a keypad lock or a touchscreen lock with multiple finishes including satin nickel, venetian bronze, and polished chrome. From august to December Kwikset deadbolts are the locks for year-round keyless entry. Kwikset smartcode home connect means our kwikset z wave locks works with amazon alexa, smartthings, and wink smart home hubs for smart home automation..Required door thickness- 1 3/8 to 2 inches. Latch is 20 minute fire rated with round corner face. TROUBLESHOOT: The lock jams and the turnpiece does not rotate smoothly: (1) The door handing process was not executed during installation.Perform the door handing process in the Installation Guide. (2) The hole in the door is misaligned.Disassemble the lock, and reinstall it without the adapter ring on the exterior side of the door. The Lock button does not lock the door. (1) No user codes are programmed.If there are no codes in the lock, the lock button will not lock the door. Program at least one user code and test the Lock button again. (2) The door handing process was not executed.Perform the door handing process, following the instructions inside the installation guide. (3) The battery is too low to lock the door.This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set.